Bonnet Protector Installation Guide | Step-by-Step Instructions

Thank you for choosing AUSGO 4WD Accessories.

Your new AUSGO Bonnet Protector is more than just an accessory—it’s a shield. Engineered to withstand New Zealand’s rugged terrain and unpredictable weather, it provides a robust defense against stone chips, gravel, and insects.

To ensure a perfect fit and long-lasting performance, please read these instructions thoroughly before you begin. Taking a few extra minutes now will ensure your protector stays secure for years to come.

This installation guide includes two methods. 

• Clip-On Bonnet Protector
• Adhesive Tape Bonnet Protector

Please follow the steps corresponding to the version you purchased.

Part A: Clip-On Bonnet Protector

Step 1: Check Fitment

Hold the protector against the bonnet edge to confirm proper alignment.

Step 2: Check Accessories

Lay out all included accessories to ensure nothing is missing.
(Please note that included accessories may vary between models—refer to the printed instructions in your package for the exact contents.)

Step 3: Clean Bonnet Surface

Thoroughly clean the front edge of the bonnet, removing all dust, dirt, and debris.

Step 4: Assemble Bonnet Protector

• If you purchased a 3-piece protector, assemble the pieces first.
• Connect the ends and secure them with the supplied screws.

Step 5: Prepare Mounting Brackets

• Attach the U-shaped brackets to the back of the protector.
• Insert the round washers and nuts through the pre-drilled holes.

Step 6: Install Protector

• Align the protector with the bonnet, ensuring the U-shaped brackets match the bonnet’s holes underneath.
• Carefully insert secure them with the No.4 screws to finalize the installation (do not overtighten).

Step 7: Final Check

Ensure all clips and buckles are secure; protector sits flush on bonnet.

Part B: Adhesive Tape Bonnet Protector

Step 1: Check Fitment

Hold the protector against the bonnet edge to confirm proper alignment.

Step 2: Clean Bonnet Surface

• Thoroughly clean the front edge of the bonnet, removing all dust, dirt, and debris.
• Ensure the surface is completely dry before proceeding.

Step 3: Apply Adhesion Promoter (Optional)

For stronger adhesion, apply adhesion promoter to the installation area.

Step 4: Position and Attach

• Peel back about 2 inches of liner from each tape section and fold it back to create a pull tab.
• Carefully align the protector in place. Starting from the center, slowly peel the liner while applying gentle, even pressure.
• Repeat until all liners are removed.

Step 5: Press Firmly

Apply firm pressure along all taped edges to ensure full contact and adhesion.

Step 6: Avoid Moisture

Do not wash or expose the protector to water for 72 hours after installation.

After Installation

• Recheck the bonnet protector after a short drive to ensure all fittings remain secure.
• For adhesive type, maximum bonding strength is achieved after 72 hours.
• Clean with mild soap and water; avoid harsh chemicals.

Note

• Installation is best done in a clean, dry environment.
• If unsure, professional installation is recommended.

Why Choose AUSGO Bonnet Guards?

• Premium UV-Resistant ABS: Built to endure the harsh Kiwi sun and freezing winters without fading, warping, or cracking.
• Vehicle-Specific Precision: Tailored specifically for your model to ensure a seamless, aerodynamic fit that complements your vehicle's natural lines.
• Ultimate Trail Defense: Provides a high-strength barrier against road debris, stone chips, and bugs—keeping your paintwork pristine.
• Easy Maintenance: Designed for practicality; it’s simple to clean and requires no specialized tools to maintain its showroom shine.

When installed correctly, your AUSGO Hood Protector delivers the perfect balance of rugged durability and sleek style. From the daily city commute to off-road adventures across the North and South Islands, we’ve got you covered.

Safe travels and enjoy the journey!